Airport Grade™ Asphalt Driveway Sealer

STEP 1: CLEAN
Clean loose debris from pavement with broom and rinse with a garden hose. Remove grease and oil with Airport Grade™ Multi- Purpose Driveway Cleaner or detergent. Treat chemical spills with Airport Grade™ Oil Spot Primer.  Follow label directions.

STEP 2: REPAIR
Repair all cracks and holes and allow to cure thoroughly.

• Up to 6 mm (1/4"): Airport Grade™ Asphalt Driveway Crack Filler or Airport Grade™ Depression Filler
• Up to 12 mm (1/2"): Airport Grade™ Depression Filler
• Over 12 mm (1/2"): Airport Grade™ Pot-Hole Filler

Allow all repairs to cure thoroughly. Follow label directions.

STEP 3: SEAL

• Do not apply if rain or temperatures below 10°C (50°F) are forecast within 48 hours
• Apply early in the day for more curing time
• Just before use, wet driveway with clean water and remove any puddles
• Wear gloves to avoid contact with sealer
• Mix thoroughly and apply undiluted with the brush side of a squeegee in 3-4 foot sections using a cross pattern to coat evenly
• Smooth out ridges and excess sealer
• Apply in a single, even coat. Multiple coats or applying too thickly will cause slow curing and cracking
• Cures to touch in 4 hours
• Normally drive-able in 24-48 hours

Tips

• For larger applications mix containers together for uniform colour
• Do not use on concrete or asphalt less than six months old
• Do not mix with coal tar pitch or asphalt/solvent-based sealer
• Do not dilute
• For exterior use only
• Keep from freezing

Coverage
23 to 38 m2 (250-400 sq. ft.) per 17.0 L pail. Coverage may vary according to surface age, porosity, weather conditions, and application method. Follow label directions.