LinkedIn Youtube Facebook Sales Rep Locator Document Search
 

Concrete & Flooring Accessories

Stone Mason® Liquid Concrete Floor Crack Filler

Product Description
Installation and
Technical Literature
Application Tips
and Instructions
Warranty

 

Stone Mason® Liquid Concrete Floor Crack Filler is specially designed for the fast repair of horizontal cracks, holes and other minor imperfections in concrete or masonry surfaces. Ready to use and water-based, Stone Mason® Liquid Concrete Floor Crack Filler dries to a gray colour to match most existing concrete.

Features

  • Ready-to-use
  • Self-leveling
  • Suitable for interior and exterior repairs

Coverage

  • Each 3.78L bottle will fill 86m (282 ft) based on a 6mm by 6mm (1/4" by 1/4") crack

 

SDS Sheets
Stone Mason® Liquid Concrete Floor Crack Filler SDS Sheet Download PDF      
Stone Mason® Liquid Concrete Crack Filler SDS Sheet Download PDF      
 

 

Surface Preparation

  1. Thoroughly clean surface area free from all dust, dirt or other loose materials, using a wire brush if necessary. Stone Mason® All-Purpose Concrete Cleaner is recommended to remove oil and grease contamination.
  2. Surface area must be dry; however, if the temperature is 27°C (80°F) or above, lightly dampen the area with water mist before applying.

Mixing

Mix by inverting, shaking and/or squeezing the bottle before opening to ensure a uniform mixture.

Application

  1. Remove the protective cap and cut the tip of the nozzle to desired size.
  2. For deep cracks squeeze one application of product into crack. Add fine sand to approximately 6 mm (1/4") from surface. Complete by filling with Concrete Floor Crack Filler. For thin cracks it may be necessary to thin material by setting the bottle in hot water for 10 minutes before use. Press or trowel crack filler into crack.

Drying Time

Dependent on wind, temperature and relative humidity. Under normal conditions at 21°C (70°F) and 55% RH, allow 1 to 2 days for complete cure. The surface is typically dry-to-touch within 30 minute following application and narrow cracks of less than 3 mm (1/8”) may be ready for traffic.

Tips

  1. Maximum crack dimension should not exceed 6 mm by 6 mm (1/4" by 1/4"). Stone Mason® Vinyl Cement Patch is recommended for use in cracks exceeding 6mm in width or depth.
  2. For exterior applications, do not apply if rain is expected within 24 hours or if temperature is expected to drop bellow 5°C (40°F). Do not apply to frozen or frosted substrates.
  3. Stone Mason® Concrete Crack Filler (cartridge) is recommended to seal cracks or joints where joint movement is anticipated.
  4. Store at a temperature above 5°C (40°F) and keep container tightly sealed.

Coverage

Each 3.78 l bottle will fill 86 m (282 ft) based on a 6 mm by 6 mm (1/4" by 1/4") crack.

Clean Up

Use soap and water while compound is still fresh.

Caution

Avoid contact with skin and eyes. In case of eye contact, flush thoroughly with water for 15 minutes and get immediate medical attention.

KEEP OUT OF REACH OF CHILDREN

KEEP FROM FREEZING

 

The consumer shall satisfy themselves of the suitability of this product for the intended purpose. Weather, applicator's skill and surface conditions are beyond manufacturer's control. We, therefore, limit our liability to replacement of defective material only, within one year of proof of purchase.