STEP 1: CLEAN Clean loose debris from the pavement with a broom and rinse with a garden hose. Remove grease and oil with Airport Grade™ Multi- Purpose Driveway Cleaner or detergent. Treat chemical spills with Airport Grade™ Oil Spot Primer.
STEP 2: PREP Repair all cracks and holes and allow to cure thoroughly.
- Up to 6 mm (1/4"): Airport Grade™ Asphalt Driveway Crack Filler or Airport Grade™ Depression Filler
- Up to 12 mm (1/2"): Airport Grade™ Depression Filler
- Over 12 mm (1/2"): Airport Grade™ Pot-Hole Filler
Allow all repairs to cure thoroughly. Follow label directions.
STEP 3: SEAL Apply in two coats. Turn pails upside down a day before prior to application. A small amount of water separation on top is normal. Material may appear brown but dries to a rich black colour. Apply early in the day for maximum benefit of daytime warmth for drying.
Apply first coat using a brush or brush side of a squeegee or roller, with thickness not exceeding that of a dime to avoid tracking or mud-cracks. Spread out excess sealer on the surface, smooth out and remove ridges. Work in a 3 or 4 foot area brushing in a cross pattern so all pores are filled.
Second coat can be applied after two hours if the product is cured and dry enough for foot traffic. Squeegees are recommended for second coat if a smooth, shiny finish is desired. If a textured finish is desired, a brush can be used for the second coat. Work in a 3 or 4 foot area brushing in a cross pattern so all pores are filled.
Follow consistent pattern for best appearance. Coatings should be applied under normal environmental conditions without thinning.
Do not apply if rain or temperatures below 4°C are forecasted in less than 24-48 hours.
Tips
- For larger applications mix containers together for uniform colour
- Do not use on concrete or asphalt less than six months old
- Do not mix with coal tar pitch or asphalt/solvent-based sealer
- Do not thin
- For exterior use only
- Keep from freezing
Coverage 14 to 18 M2 (150-200 sq. ft.) per 17.0 L pail. Coverage may vary according to surface age, porosity, weather conditions, and application method. Follow label directions.
|